Locker Locks

Ensure that the plastic clear battery tab at the back of the lock has been pulled and the lock has been initialised

The lock is in one-time-user mode. This means that the lock automatically resets after each use ready for the next user. Contact your locker administrator to change the operating mode to permanent user mode.

The battery life of the Minik10 is 10 years, based on 10 openings per day!

Please note that Programming parameters 2, 3 and 7 will reduce this when active. If the battery dies whilst in the locked position

Contact your locker administrator to provide access to your locker via the service password.  The Service password can be used to inspect the contents of the lockers, without overriding the original user code.

The flashing of the red LED indicates that the Minik10 battery is getting low and must be replaced immediately. If the Minik10’s Battery dies whilst in the locked position, contact your locker administrator to provide the Emergency Power Device and provide access to your locker.

This is due to over tightening the mounting parts during installation. If the Hex nut at the back is fastened to tight, the pressure on the lock will stop the locking mechanism from engaging.

For first time use – The factory default code for the Ultra Combi Cam range is all 0’s.

Write your new desired code down. Dial up your existing combination in line with the arrow on the front. Once the current combination is entered , press and hold the round button, located on the top of the lock. Continue holding the button down and do not release it until your new combination is completely set.

Ensure that you store your combination in a safe and secure location.

Ensure that the combination digits are correctly aligned with the arrow on the face of the lock. Spin off the dials and then try your combination once more. If the combination doesn’t work, contact your locker administrator to check your previous code with the code discovery feature using the master key or probe.

7440 – Contact your Locker administrator who can provide your lost code using the master override key.

7432 – Contact your locker administrator who can provide access to your locker via the master key. Once inside the locker, insert the code discovery probe into each hole, spinning the dials on the front of the lock until it is stopped.

Once your combination has been discovered, please ensure that you make note of it and store it in a safe and secure location.